Back on its track in about 10 minutes, for most doors. $12.
It dropped off the track, or it jumps off every few days. It won’t close or lock, and a heavy panel that drops can fall. A door that jumps its track has a reason: a healthy door on a healthy track does not come off. The kit shows you how to lift it back in safely, then its 2-minute check finds the reason: worn or broken rollers, a bent track, debris, or a wheel that doesn’t match the rib. Fix that, and it stays on.
★★★★★161 Google reviews · From Mr Door Pro, Orlando · Back on its track and gliding, or your money back
From Mr Door Pro. By email right after you pay: the steps, the videos and your photo assistant.
$12 is less than one good roller ($25 to $40). A Mr Door Pro visit starts at $120, and a new sliding door costs $3,000 to $6,000.
Secure payment by Stripe · Your kit arrives by email right after you pay · 30-day money-back guarantee
The panel often weighs 60 to 150 pounds. Lift by the frame, never the glass. One person can lift a light panel; a heavy one takes two.
Lower the rollers, lift the panel straight up into the head track, swing the bottom in and set it on the rib. Then raise the rollers until it slides free.
A flashlight along the track, the gap at the frame, the bottom of the panel. A table sends you to the fix your door needs.
The $2 steel wire brush we use on our own jobs, a vacuum and degreaser. Debris is one of the reasons doors jump.
Straighten a small bend with a block of hardwood, or put a cap over a worn rib. And when it needs a pro.
How to tell, how to measure the old one and which to buy, with a wheel edge that matches your rib. The videos show us changing them.
I’m Davi. I own Mr Door Pro, and fixing sliding doors is all we do. Every step in this kit is how we do it on real jobs, written down for one job: a door that came off its track, and how to keep it on.
“Davi did a great job fixing the sliding door that had bugged my wife for the last 4yrs. Quick service, reasonable prices. Would recommend.”Aaron W. · Google review
“I got an appointment for an estimate right away and they were able to fix my door at the same time. Davi was prompt, efficient and pleasant.”Tracy M. · Google review
Real reviews of Mr Door Pro on Google: 161 reviews, 5.0 rating.
If your door doesn’t stay on its track and glide after you follow the kit, write to us within 30 days and we refund every dollar.
Near Orlando? We come and fix it: free estimate at your home.
A light panel, yes: one person can lift it. A heavy one takes two. The kit tells you how to tell, and how to hold it: by the frame, never the glass.
Screwdrivers, pliers, a stiff putty knife, a rubber mallet and a short piece of 2x4 to put it back. A $2 steel wire brush, a vacuum and degreaser for the track. A bent spot also needs a block of hardwood, a hammer and a fine metal file. The kit lists every one.
The check takes 2 minutes and cleaning the track about ten. If the rollers are gone, plan half a day: our technicians take about two hours per panel.
A door that jumps its track has a reason: worn or broken rollers, a bent track, debris, or a wheel edge that doesn’t match the rib. The kit’s check finds which one is yours, so you fix the cause, not just put it back.
The kit shows how to tell, how to measure your old roller and which one to buy. The videos show us changing them on a real job, and your assistant walks you through the swap on your door.
Measure the old one the way the kit shows: housing size, wheel size and material, grooved or flat edge, one or two wheels, where the screw goes. Send the photos and measurements to your assistant. Still not sure? Reply to your kit’s email and we tell you exactly which one to buy.
If your door doesn’t stay on its track and glide after you follow the kit, write to us within 30 days and we refund every dollar. Near Orlando? We come and fix it: free estimate at your home.
Those panels are much heavier and built differently. The panel comes out and goes back with two people and glass suction lifters, and for most people it is a job for a pro. Send your assistant a photo first.
No subscription: $12, one payment. Right after you pay, an email arrives from diy@mrdoorpro.com with the kit as a PDF and the link to your videos and your photo assistant.
$12, one time. Back on its track and gliding, or your money back.
Get the kit · $12